AEM CAI on 2200 engine

From JBOK Wiki

Guide for installing AEM Cold Air Intake on the 2200 Engine in Jbody cars.

Submitted by Professor J January 2006.

Items included with intake should be as in the picture below:

Step 1: Disconnect your cars battery and remove from engine bay.

Step 2: Remove you factory airbox, expansion box (says 2200 on it), bong in dirver side fender, air tube with IAT sensor, and strut tower brace if equipped.

Step 3: Remove tab from underhood fuse box and place fuse box out of your way (tab is no longer needed).

Step 4: Install supplied bolt and washer in the inside wall of fender.

Step 5: Install METAL spacer and place shorter intake tube into the hole left by the stock air box, Secure with nut and washer.

Step 6: Place supplied rubber hump hose onto your throttle body and secure with supplied clamp.

Step 7: Install rubber grommet into hole on the side of the larger intake tube. Install the unpluged IAT sensor into the grommet.

Step 8: Install final rubber boot onto the end of the smaller intake tube and secure with supplied clamp.

Step 9: Install the larger intake tube into the rubber boot on the end of the smaller tube and the hump hose on the throttle body.

Step 10: Place rubber spacer in tab hole that holds the fuse box on, secure with supplied nuts and washers.

Step 11: install the supplied breather hose from the rocker cover to the inlet on the side of the intake.

Step 12: Use supplied zip-ties to route throttle cable and cruise control cable (if cruise is available) to top of the intake.

Step 13: Install the supplied AEM air filter to the end of the smaller tube located in the inner fender.

Step 14: Reinstall battery and IAT sensor connector.

Final product....

Oh and look a the detail :)