View source

== Guide for installing AEM Cold Air Intake on the 2200 Engine in Jbody cars.== 
''Submitted by [http://jbok.org/memberlist.php?mode=viewprofile&u=3 Professor J] January 2006.''


Items included with intake should be as in the picture below:

[[image:install002.jpg|500px]]

Step 1: Disconnect your cars battery and remove from engine bay.

Step 2: Remove you factory airbox, expansion box (says 2200 on it), bong in dirver side fender, air tube with IAT sensor, and strut tower brace if equipped. 

[[Image:install003.jpg|500px]]

Step 3: Remove tab from underhood fuse box and place fuse box out of your way (tab is no longer needed).

Step 4: Install supplied bolt and washer in the inside wall of fender. 

[[Image:install017.jpg|500px]]

Step 5: Install METAL spacer and place shorter intake tube into the hole left by the stock air box, Secure with nut and washer.

[[Image:install018.jpg|500px]]

Step 6: Place supplied rubber hump hose onto your throttle body and secure with supplied clamp. 

[[image:install013.jpg|500px]]

Step 7: Install rubber grommet into hole on the side of the larger intake tube. Install the unpluged IAT sensor into the grommet. 

[[image:install010.jpg|350px]][[image:install011.jpg|350px]]

Step 8: Install final rubber boot onto the end of the smaller intake tube and secure with supplied clamp. 

[[image:install019.jpg|500px]]

Step 9: Install the larger intake tube into the rubber boot on the end of the smaller tube and the hump hose on the throttle body. 

[[image:install020.jpg|500px]]
[[image:install014.jpg|500px]]

Step 10: Place rubber spacer in tab hole that holds the fuse box on, secure with supplied nuts and washers. 

[[Image:install006.jpg|500px]]
[[image:install007.jpg|500px]]
[[image:install008.jpg|500px]]

Step 11: install the supplied breather hose from the rocker cover to the inlet on the side of the intake. 

[[image:install021.jpg|500px]]

Step 12: Use supplied zip-ties to route throttle cable and cruise control cable (if cruise is available) to top of the intake. 

[[image:install022.jpg|500px]]

Step 13: Install the supplied AEM air filter to the end of the smaller tube located in the inner fender. 

[[image:install024.jpg|500px]]

Step 14: Reinstall battery and IAT sensor connector.

Final product.... 

[[image:install025.jpg|500px]]

Oh and look a the detail :) 

[[image:install023.jpg|500px]]